EN 10265 Grade 250-100-TF 183
EN 10265 Grade 250-100-TF 183 introduction
Cold rolled pole sheet grade is classified according to its yield strength (EN 10265:1995). As well as guaranteed mechanical properties, it has guaranteed magnetic properties, but unlike other electrical steel grades, its magnetic properties are determined under direct current (DC) conditions. Full magnetic characterisation curves in DC and also at various frequencies are available on request.
High yield strength values allow this grade to withstand strong electromechanical forces. As well as excellent DC magnetic properties significantly superior to the requirements of the standard, this grade perform well on loss and induction levels at 50 Hz, thanks to a special chemical composition.
This data sheet deals with the cold rolled grade that conform to the standard.
Equivalent material: IEC 250-100-TF 183
EN 10265 Grade 250-100-TF 183 general
| Property |
Value |
Comment |
| Elongation |
Elongation of 16 % |
min. | for thickness 1 mm | Transverse | A80 | Guaranteed |
| - |
Elongation of 30 - 40 % |
for thickness 1 mm | Transverse | A80 | Typical values |
| Hardness, Vickers |
Hardness, Vickers of 130 - 160 [-] |
Typical values for thickness 1 mm |
| Tensile strength |
Tensile strength of 325 MPa |
min. | Guaranteed |
| - |
Tensile strength of 420 - 470 MPa |
Typical values |
| Yield strength |
Yield strength of 250 MPa |
min. | Guaranteed | Transverse |
| - |
Yield strength of 290 - 340 MPa |
Typical values | Transverse |
| Yield to strength ratio |
Yield to strength ratio of 0.68 - 0.73 [-] |
Typical values |
EN 10265 Grade 250-100-TF 183 thermal
| Property |
- |
- |
| Application areas |
| Other |
| Min width |
Max width |
Min width |
Max width |
Min width |
Max width |
Min width |
Max width |
| 250-100-TF 183 |
1 & 2 |
1030 |
1230 |
600 |
1200 |
250 |
600 |
400 |
1130 |
|
EN 10265 Grade 250-100-TF 183 mechanical
| Property |
Value |
Comment |
| Guaranteed polarization |
Guaranteed polarization of 1.6 [-] |
min. | for thickness 1 mm | in DC at 5000 A/m |
| - |
Guaranteed polarization of 1.83 [-] |
min. | for thickness 1 mm | in DC at 15000 A/m |
| Typical polarization |
Typical polarization of 1.71 [-] |
min. | for thickness 1 mm | in DC at 5000 A/m |
| - |
Typical polarization of 1.9 [-] |
min. | for thickness 1 mm | in DC at 15000 A/m |
Count on us for seamless collaboration, exceptional service, and a comprehensive range of steel products to fuel your success.
-- Our promise
Get a quote